S
I used 50mm plastiflex pipe. 50mm is a little on the small side but it was a major hassle because there is very little room to work with. This supplements the OEM system which picks up air just in front of the radiator. The problem I see is that the factory inlet faces the radiator instead of facing forward. The air flow has to travel through a 180 degree turn and two 90 degree turns before in can enter the air filter housing .
See the images and you can see what I have done.
I am not 100% happy with the front air inlet at the moment, It needs a tidy up and I may add a small section of some type of mesh material. I am open to suggestions on how to make it look better from the front view.
View attachment 216
View attachment 217
View attachment 218
View attachment 219
View attachment 220
View attachment 221
View attachment 222
See the images and you can see what I have done.
I am not 100% happy with the front air inlet at the moment, It needs a tidy up and I may add a small section of some type of mesh material. I am open to suggestions on how to make it look better from the front view.
View attachment 216
View attachment 217
View attachment 218
View attachment 219
View attachment 220
View attachment 221
View attachment 222
Last edited: